![[logo] US EPA](http://www.epa.gov/epafiles/images/logo_epaseal.gif){kind=logo}
Installing the System
PESTAN
PESTAN is distributed by the EPA's Center for Subsurface Modeling Support (CSMoS) on a single IBM-formatted 5.25 or 3.5 inch diskette. PESTAN version 4.0 includes the following files.
|
PESTAN.FOR |
PESTAN.INP |
|
PESTAN.EXE |
ALDCB1.INP |
|
SHOW.EXE |
PESTAN.OUT |
|
WHAT.EXE |
ALDCB1.OUT |
|
PMENU.BAT |
LEACHBTC.DAT |
|
FORMENU1.TXT |
LEACHFLX.DAT |
|
FORMENU2.TXT |
SOILCON.DAT |
|
CHGNAME.TXT |
|
Prior to installing or implementing the program make a back-up copy of
PESTAN using the DISKCOPY command of MS-DOS or PC-DOS. Once completed,
copy the PESTAN files to the hard disk in a selected directory. Because
the program requires ample storage for the output files, approximately
700KB, the program should be run from the hard disk. In addition, a text
editor will have to be defined in the AUTOEXEC.BAT file. The text editor
could be DOS edlin, DOS edit, Norton Classic editor, WordPerfect, or any
other commercial editor. Define the text editor in AUTOEXEC.BAT (including
its path). For example,
SET EDITOR=C:\WP51\WP
Finally, the ANSI.SYS driver (see your MS-DOS manual) must be installed in the CONFIG.SYS file. This is done by adding a statement such as
DEVICE=C:\DOS\ANSI.SYS
It is important that the correct path for ANSI.SYS is given.