![[logo] US EPA](http://www.epa.gov/epafiles/images/logo_epaseal.gif){kind=logo}
Installing the System
VLEACH
VLEACH version 2.0 is distributed by the EPA's Center for Subsurface
Modeling Support (CSMoS) on a single IBM-formatted 3 1/2-inch diskette.
VLEACH version 2.0 includes the following 16 files.
|
THOMAS.FOR |
VLEACH.FOR |
|
VLEACH.EXE |
SAMPLE.INP |
|
TEST.INP |
SAMPLE.OUT |
|
SAMPLE.PRF |
SAMPLE.PRM |
|
SHOW.EXE |
FORMENU2.TXT |
|
FORMENU1.TXT |
CHGNAME.TXT |
|
VLMENU.BAT |
SOILIMP.DAT |
|
GWIMP.DAT |
WHAT.EXE |
Prior to installing or implementing the program make a backup copy of
VLEACH. Once completed, copy the VLEACH files to the hard disk in a selected
directory. Because the program requires ample storage for the output files,
the program should be run from the C drive. In addition, a text editor
will have to be defined in the AUTOEXEC.BAT file. The text editor could
be DOS edlin, DOS edit, Norton Classic editor, WordPerfect, or any other
commercial editor. Define the text editor in AUTOEXEC.BAT (including its
path), for example,
SET EDITOR=C:\WP51\WP
Finally, the ASNSI.SYS driver (see your MS-DOS manual) must be installed in the CONFIG.SYS file. This is done by adding a statement such as
DEVICE=C:\DOS\ANSI.SYS
It is important that the correct path for ANSI.SYS be given.